Cleaning and maintenance of sponge cutting machine equipment

How should the cleaning and maintenance of sponge cutting machine equipment be carried out? The following is a detailed introduction to you.

Electrical equipment should be kept clean frequently to prevent oil, water and dust from immersing.

In case of a short circuit, replace the fuse with the same capacity, you can use tin and silver wire, it is recommended not to use copper wire as a substitute.

Rotary motors use rolling bearings, and the bearings should be cleaned (with kerosene or diesel oil) and replaced with clean grease every other month. Gears, sprockets, etc. should be cleaned before get off work every day and then lubricated.

When motors and electrical appliances are parked for too long (more than 1 month later) and are used again in the wet season, the electrical insulation should be re-examined and subjected to dehumidification treatment, that is, when the voltage is reduced to 1/3 of the rated value, the motor will be idling 48 Hours to gradually expel moisture, and then run at full pressure to be safe.

Note that the mechanical grounding condition must be good. If the end surface of the grounding screw is oily or corroded, it should be cleaned at any time.

Pay attention to whether the exposed hoses and wires are skewed, broken or damaged. (sponge cutter)

Always check the sensitivity of each contact and interlock.

Use mechanical and electrical equipment in accordance with the instructions in the instruction manual.